XLR connector from the outside.
interior of monitor speaker, showing amplifier board. Hot glued some of the components and connector.
XLR connector from the inside. Dark blob at right contains 1:1 balanced-to-unbalanced transformer (XLR to high-Z)
A speaker in the hand..
This is the back of what used to be the speaker-terminal block. It now houses the 12VDC barrel jack and the power LED.
Inside of box. I was considering mounting the AC power supply inside the box.. not enough space.
Outside of speaker, showing back of former terminal plate, now housing power jack and power LED. The red LED was too bright in practice (would be distracting from across the sanctuary), so I covered it mostly with tape.
Front of speaker showing volume control.
Front of speaker with volume knob.
speaker on table.
Back of speaker
Bees' new rack. equipment below was evicted to make room..
Bees rack, open
RAID going into test machine
RAID disk assembly line.. mounting all 5 250G disks into trays
The new 3/8" mount on the truck
side view of mount
Ben with 2m colinear antenna